MAN0094 (11/15/2002)1004624 SUB-FRAME MOUNTING KITWoods Backhoe Model:BH6500/7500mounting toKubota Tractor Model:MX50002WD & FWAequipped with or w
8 InstallationMAN0094 (11/15/2002)SUB-FRAME INSTALLATION Cont’dInstall Rear Mount 1. Slide rear mount (5) into slots of rear hangerbracket (4).2.
Installation 9MAN0094 (11/15/2002)SUB-FRAME INSTALLATION Cont’dSub-Frame Fit-Up1. Rotate front end of sub-frame up into the fronthanger.NOTE: Adjust
10 InstallationMAN0094 (11/15/2002)SUB-FRAME INSTALLATION Cont’dAttach Sub-Frame to Backhoe1. Align six holes on the backhoe with holes on sub-frame
Installation 11MAN0094 (11/15/2002)HYDRAULIC INSTALLATION Keep hands and body away from pressurizedlines. Use paper or cardboard, not hands or otherb
12 InstallationMAN0094 (11/15/2002)SUB-FRAME & BACKHOE INSTALLATION TO TRACTORMount Sub-Frame & Backhoe to Tractor This mounting kit is desig
Installation 13MAN0094 (11/15/2002)SUB-FRAME & BACKHOE REMOVAL FROM TRACTORRemove Backhoe With Sub-Frame The only time the backhoe may be operate
14 InstallationMAN0094 (11/15/2002)SUB-FRAME & BACKHOE INSTALLATION TO TRACTORNOTESStore Hydraulic Pump1. Disconnect pump (1) from tractor PTO.2
PARTS 15MAN0094 (11/15/2002))1004624 SUB-FRAME MOUNTING KIT1519211920231912427262518171616132346789522CD6130Serial Number PlateLocated inside sub-fram
16 AppendixBolt Torque & Size Charts (Rev. 8/14/2002)BOLT TORQUE CHARTAlways tighten hardware to these values unless a different torque value or t
Appendix 17Bolt Torque & Size Charts (Rev. 8/14/2002)BOLT SIZE CHARTNOTE: Chart shows bolt thread sizes and corresponding head (wrench) sizes for
ii Introduction (Rev. 11/6/2002)TO THE DEALER:Assembly and proper installation of this product is the responsibility of the WOODS dealer. Read manual
F-8494 (Rev.11/6/2002)Woods Equipment Company2606 South Illinois Route 2Post Office Box 1000Oregon, Illinois 61061815-732-2141 tel815-732-7580 faxWAR
F-3079 (Revised 11/6/2002)Woods Equipment Company2606 South Illinois Route 2 Post Office Box 1000Oregon, Illinois 61061815-732-2141 tel815-732-7580 fa
Woods Equipment Company2606 South Illinois Route 2Post Office Box 1000Oregon, Illinois 61061815-732-2141 tel815-732-7580 faxwww.woodsonline.com© 2002
Table of Contents 1MAN0094 (11/15/2002)TABLE OF CONTENTSINTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2 SafetyBH6500/7500 SFMK (11/15/2002)_______________________________________________INSTALLATION This Sub-Frame Mounting Kit is to be used onlyfor t
Safety 3BH6500/7500 SFMK (11/15/2002) Remove seat and upper support assemblybefore installing or removing backhoe from tractor.Failure to comply may
4 InstallationMAN0094 (11/15/2002)BACKHOE SUB-FRAME INSTALLATION This mounting kit is designed to providesecure mounting and adequate operator clear-
Installation 5MAN0094 (11/15/2002)SUB-FRAME INSTALLATION Cont’d Always wear relatively tight and belted cloth-ing to avoid entanglement in moving par
6 InstallationMAN0094 (11/15/2002)SUB-FRAME INSTALLATION Cont’dInstall Front MountFor Tractors with Kubota LA852 and LB702 or Woods 1009, 1012, 1016
Installation 7MAN0094 (11/15/2002)SUB-FRAME INSTALLATION Cont’dInstall Rear Hanger Bracket1. Install rear hanger bracket (4) under tractor,between t
Comments to this Manuals